CLICK HERE TO READ PART 1/2
The power amp can be connected to the cabinet through a back panel which has the input jacks, and in this is very important the impedance (click here for a dedicated article): we must make sure that the power amp impedance matches the one of the head if we want to avoid damaging it.
Many cabinets have different inputs for different impedances, or a selector.
Speaking of speakers (click here for a dedicated article), we choose among a big variety: usually guitar speakers goes from 5 inches to 15 inches, and bass speakers ranges from 10 to 15, but there are also in this case exceptions.
The classic speaker for guitar has a 12 inches radius, while for bass are also very common 10 inches or 15.
The rule of thumb is that the smaller the radius, the more boxy and trebly the sound will be, the bigger, the more bass content will produce.
Sometimes bass amps have different size speakers to reproduce singularly the high end (tweeters) and the low end (woofers), and the division of the tone between the two speakers is done by a crossover circuit built in the cab.
Cabinets can also be connected between them in a method that is called "daisy chaining": the amp goes into a cabinet, and from that cabinet into another connecting them in parallel, but this option must be present in the back panel of the cab.
A final interesting note is about recording.
When recording a guitar cabinet (click here for a dedicated article) we must choose the speaker that sounds better (through some trial and error), since usually there is some difference between speaker and speaker in the same cabinet, but it's important to point out that in this case the rule "the bigger the better" does not apply: sometimes 1x12 cabs will sound more focused and clear than a 4x12, so consider spending a bit more time in the studio experimenting before making your decision.
For bass instead is a common practice to record both the d.i. sound and the microphoned one in order to blend them, since is quite hard to obtain all the tone we need just by microphoning the cabinet.
About recording is worth to mention also the isolation cab (like the one in the picture): a cabinet that can be microphoned like a regular one and that is closed by an insulation lid so that it produces no sound on the outside: the only thing audible is the sound captured by the microphones, that is sent to a mixer for recording or live mixing purposes. Sometimes touring bands use this for the signal to be sent to the p.a., to avoid microphoning one of the stage cabs, but this method is starting to fade as speaker emulations are becoming increasingly common also among touring bands.
I hope this was helpful!
Become fan of this blog on Facebook! Share it and contact us to collaborate!!
Nessun commento:
Posta un commento