sabato 5 ottobre 2019

5 ways to improve an amp sim guitar tone



Hello and welcome to this week's article!
Today we're starting a new serie called "How to improve", in which we will add some element to our basic mixing articles.
This time we're talking about 5 ways to improve our amp sim guitar tone, which even if we are using some high end plugin, still needs some polish before it can perfectly sit in the mix.
These tips are to be applied after recording, editing, finding the right guitar amp sim and tweaking it.

1) Impulse responses: impulse responses are the single most revolutionary thing happened to the world of guitar tones in decades, since they can change radically a sound and make it realistic in a way that few years ago was unthinkable without microphoning a real amp.
Get yourself a nice collection of impulses, at least a couple of hundreds, it doesn't matter whether free or paid, just make sure to have enough variety to cycle through them until you find the one (or the combination of more than one) that fits perfectly the song, and in order to do it, use a referencing track with a sound similar to what you have in mind.
A good starting point would be our free IR Pack Trident, which has 14 impulses ready to use.

2) Create a guitar bus: route all the guitar tracks that should have similar tones (e.g. the rhythm guitar tracks) into a stereo guitar bus, in order to control with one fader the general presence of guitars in the song.

3) Compress the minimum necessary: the general rule here is "the more the gain = the more the natural compression", so if we have clean guitars we will need to compress more, while if we have high gain ones, we're going just to use a multiband compressor in the low end area, shaving off a couple of db when needed in the area from 80 to 350hz (usually during palm muting).

4) Equalize with wisdom: here the general rule is "boost wide, cut narrow". We could spend hours talking about how to clean a guitar tone, but in this article let's just add the fact that we need to find balance: the sound must be natural, similar as if it's coming out of a real amp, so:
- high pass up to 50 to 80hz
- if the guitar still sounds weak and lacks of presence, add some body in the area between 1000 and 2000hz, finding where it suits, with a wide bell boost of 1 or 2 db.
- cut a couple of db with a narrow bell in the 4k area, sweeping the eq until you find the "nails on a fingerboard area"
- add some air, with a wide bell around 8-10khz

5) Don't be afraid of saturation: this is another tool to be used if our tone (especially if clean or overdriven) is too weak, thin, and we can't solve by using the eq; a touch of tape or tube saturation can add the weight and the midrange our tone needs without altering too much the sound.
This tool can be used on other instruments too!


I hope this was helpful!


Become fan of this blog on Facebook! Share it and contact us to collaborate!! 

Nessun commento:

Posta un commento